1	Yorkshire Terrier Top Knots Steps to create a beautiful Yorkie top knot.
2	Step 1 Using a rat-tail comb, create a clean part, up the center of the dog’s muzzle. Part the hair on the bridge of your dog’s nose, horizontally (as shown in the picture). Leave a slight “V” shape in-between the eyes at the top-end of the part.
3	Step 2 Part the hair from the outside corner of the eye, back to the center of the head. Be sure to make as straight a line as possible. The straighter the line, the cleaner your topknot will appear.
4	Step 3 Make a part across the center back of the head (from ear-to-ear). Once again, keep it clean! You may have to part it a few times before you achieve a completely clean part.
5	Step 4 After the part on the middle-of-the-head is complete. Separate that portion into two even sections (one in front of the other). These two sections together will become the bubble.
6	Step 5 To each section spray on the Pure Paws Ultra Volumizing Spray Gel to achieve maximum volume in your bubble. Begin your bubble, by teasing the back portion of the part. Once the back is teased, then tease the front section of the part.
7	Step 6 Now tease both sections together to create one bubble. Tease it all the way around the bubble; left, right front and back.
8	Step 7 Smooth out the bubble with a soft horse hair brush or even a baby brush. The reason for using such a soft brush is so you don’t destroy or flatten the bubble. Use the Pure Paws Ultra Volumizing Spray Gel to keep stray hairs from sticking out of your bubble.
9	Step 8 Now tie the topknot up and be sure that the majority of the volume (teased portion) is at the base. While doing this be extra careful not to flatten the bubble.
10	Step 9 Shape the bottom bubble by pulling the hair firmly in different directions using the rat- tail end of the comb. This is a delicate procedure and the bubble can be misshaped easily.
11	Step 10 Now anchor the bubble and create a fuller shape. In order to do this, separate the hair and grab a small portion from the center back part of the pony tail (as shown in picture). Pull firmly and repeat Steps 9 and 10 as many times as necessary.
12	Step 11 Once the bubble is in place now you can work on the fan. Start by teasing the back part of the fan (see picture). This will create volume. Be careful not to push down too hard or else the bubble could be damaged in the process.
13	Step 12 After you have acquired the preferred amount of volume on the fan, fold the teased portion back and place a rubber band on it to hold it in place ( use two if necessary).
14	Step 13 Now it’s time to clean up the bubble and the fan. To do this spray some Ultra Volumizing Spray Gel on the rat-tail end of the comb and smooth over all the loose hairs. After you have the look you want, shield the dog’s eyes and apply a decent amount of the spray gel or hair spray to hold the topknot in place. One secret of mine is to sprits a little extra spray at the base of the bubble in the back.
15	Step 14 After you are done, apply the bow (carefully and slowly) and admire your work.
16
17	"Try all of our Grooming..." Try all of our Grooming Products For Champion Results. Pure Paws Best Ingredients = Best Results